SWTD1P4L WIRELESS REMOTE LAUNCH CONTROLLER
No Amateur Radio License Required
 Set up and break down takes less than 5 minutes!
Comes with everything you need including kevlar blast bag, 12 volt power supply with 2 sets of primary & rechargeable batteries.*
Tested Range: 1 Mile
  [3yr. warranty includes free relay replacement and shipping ]

1399.00

                                                                                       Email Your Name, Phone Number and Time to Call to Order   

                                                                                                                                                                                                                                    

The SWTD1P4L includes:
     -  User selectable security code. 
     - Timer to shut power off from 1 to 15 minutes as additional safety when connecting cables to igniters to ensure safety until launch area cleared.  
     - Magnetic key to turn the power on and off.
     - Remote control transmitter has a safety interlock key.
     - Reverse polarity protection.
     - Four power outlets with each outlet powered up by a 20 amp relay continuous power (40 amps temporary power.)**
        Note:  Two replacement relays included in case.
     - Four 12' cables with alligator clips to attach to igniters and NOX Solenoids and one 6' cable with battery clips to connect to a 12 volt DC power supply.
         Notes:  Each cable (except power cable) comes with a piezo buzzer permanently attached behind the plug to test relay and to indicate cable is powered up.
                    Extension cords can be used to increase length.
     - One Transmitter antenna and one Receiver antenna.
     - 12 volt AA primary or rechargeable batteries power supply (not recommended for more than six launches without replacement).
     - Antenna connection cover with chain.
     - Kevlar blast bag with anchor spikes to protect case from large motors.
 
Transmitter Specifications:

Manufacturer's General Specifications
Operating Temperature: -4° to +140° F (-20° to +60° C)
Receiver Type: Superheterodyne
Sensitivity: -118 dB (minimum)
Selectivity: 6 KHz
Carrier Frequency: 27.255 MHz
Number of Codes: 65,536
Code Setting Method: DIP switch programming
Antenna Impedance: 50 Ohms
Range Manufacturer specs 2 miles. SWT tested 1 mile city

SWT's General Specifications
Xmtr & Rcvr Interlock s PhoPhone Jack

*   The battery pack  comes with two sets of  8 AA Lithium Primary batteries plus two sets of 8 NiMH batteries with chargers.  Lithium Primaries and NiMH will ignite most matches. Not intended for substained high drain ormultiple launches without replacement of batteries. For heavy demand, power cord with attached alligator clips to attach to external 12 volt power supply
    included.
**   The SWTD1P4L can be configured to support 4 extra relays for a total of 8 relays with any combination of momentary and toggle on/off modes desired- add $300.


Need More Info?